JOBOBIKE SAM Bedienungsanleitung Seite 10

Step 6 Adjust the saddle height
Move the saddle up or down to your desired saddle height.
Do not raise the saddle post exceeding the minimum
insertion mark on the saddle post. Close the quick release
lever and make sure the lever is tighten enough when
locking the saddle post.
Step 7 Adjust the saddle angle
or position
Release the screw with a
you can move the saddle to the left or right to change the
position. Also you can change the angle of the saddle at
the same time to make it more comfortable while riding.
Step 8 Install the pedals
The "L" mark refers to the left pedal.
The "R" mark refers to the right pedal.
Tighten the right pedal clockwise and tighten the left pedal
anticlockwise with the 15# wrench.
N o t e : p l e a s e c a re f u l ly t h re a d e a c h p e d a l i n t o i t s
appropriate crank set.
10
6# hexagon wrench and then