Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Height Adjustment
for Head Support and
Shoulder Harnesses
See images
-
8
10
8
When used in rearward facing
mode, the shoulder harness
height must be even with or just
below the top of child's shoulders.
If the shoulder harnesses are not
at proper height, the child may be
thrown from the enhanced child
restraint in case of an accident.
9
When used in forward facing
mode, the shoulder belt guides
must be even with or just above
the child's shoulders.
Please adjust the head support
and shoulder harnesses to proper
height according to the child's
height.
10
Squeeze the head support
10
adjustment lever
-1,
meanwhile pull up or push down
the head support until it clicks into
one position. The head support
10
-2
positions are shown as
As the headrest is adjusted up
(from 6th-9th position), the sides
of the child restraint automatically
move outward to provide more
shoulder room.
Rearward
Facing Mode
(Child height 40cm-105cm/
max. 22kg)
See images
-
11
21
Please install the child restraint on
the rear vehicle seat, and then put
the child in the child restraint.
Installation for Rearward
Facing Mode
Please adjust the enhanced child
restraint to the desired recline
position (2 positions for rearward
facing mode). Align the top
reclining indicator with one of the
bottom white numbers.
Make sure the shoulder harness is
adjusted to proper height before
installing this enhanced child
restraint.
When installing and adjusting the
safety belts, make sure that both
the shoulder belt and the lap belt
are not twisted and will not stop
the safety belts from functioning
properly.
11
Pass the vehicle lap belt through
the vehicle lap belt slots.
12
Then engage the vehicle buckle
tongue into the buckle.
Vehicle lap belt must pass
underneath Body Support.
13
Pass the vehicle shoulder belt
through the two rear-facing
vehicle belt slots at the back of the
enhanced child restraint.
14
Open the belt lock off and insert
the shoulder belt through it.
Ensure the belt lock off is
completely closed when not in
use to prevent injury, or damage
to vehicle upholstery.
15
Press the enhanced child restraint
down firmly and pull the vehicle
shoulder belt to fasten the
enhanced child restraint securely.
15
15
-1 &
-2
Ensure to close the lock-off after
checking the enhanced child
restraint is securely fastened.
15
15
-3 &
-4
Keep your fingers off when closing
the lock-off clips to avoid injury.
EN
The enhanced child restraint can
not be used if the vehicle safety
belt buckle (female buckle end) is
too long to anchor the enhanced
child restraint securely.
Double check that the enhanced
child restraint is securely installed
and does not move on the vehicle
seat.
16
Correctly assembled vehicle belt is
16
shown as
Ensure that the vehicle lap belt
passes through the vehicle lap
16
-1
belt slot.
Ensure that the vehicle shoulder
belt passes through the rear-
16
facing vehicle belt slot.
-2
The vehicle buckle tongue
is engaged with the buckle
16
correctly, as
-3
9
Werbung
