Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Note: The AR7110/AR7110R uses a specifically designed switch. Conventionally
wired switches are not compatible with the AR7110.
IMPORTANT: The AR7110 and AR7110R require that at least one remote receiver
(included) be plugged into port B or R to operate.
Applications
• All sizes of nitro powered helicopters
• 500-class and larger electric helicopters
Specifications:
AR7110/AR7110R
Type: DSM Full Range receiver
Channels: 7
Modulation: DSM2, DSMX
Dimensions: 1.86 in x 1.58 in x 0.56 in (47.3mm x 40.2mm x 14.2mm)
Weight: 1.1 oz (32.5 g)
Voltage range: 6.0 to 10.0 volts/ 5 to 7 cell NiMH or 2-cell LiPo*
Minimum receiver operational voltage: 3.5 volts
Minimum regulator operational voltage: 5.5 volts
Output voltage: Rudder, Aux 2, Throttle 2, Gear 2 = 5.2 volts/ all other channels
unregulated (for high voltage compatible servos only)
Max regulated channel current: 2 amp continuous
Resolution: 2048
Switch: Soft Switch (Switch port can also be used with charge adaptors
Connector type: EC3
Remote Receiver
Dimensions LxWxH: 1.02 in x 0.80 in x 0.27 in (25.8mm x 20.2mm x 6.8mm)
Weight: 0.1 oz (5.0 g)
CAUTION: When the battery is connected to the AR7110/AR7110R a low
current drain of less than 1mA occurs even when the soft switch is turned
off. If the system is going to be stored for any length of time it' s important that the
battery be disconnected from the AR7110 to prevent overdischarge.
Items Included
SPMAR7110/SPMAR7110R AR7110/AR7110R Receiver
™
SPM9545 Remote Receiver
SPM9011 9-inch Remote Extension Lead
SPM6820 Soft Switch
SPM6821 Charge ON/OFF Adaptor Lead
SPM6823 Backplate Rpm Sensor (AR7110R only)
SPM6803 Bind Plug
Instruction Manual
7
EN
Werbung
