Spektrum AR7110 Bedienungsanleitung Seite 23

2.4GHz Troubleshooting Guide
Problem
Aircraft will not
"throttle up"but
all other controls
seem to function
LED on aircraft
remains flashing
and cannot be
controlled by
transmitter
Controls appear to
be reversed after
binding to a dif-
ferent transmitter
Aircraft does not
function after
connecting flight
battery and aircraft
smells burnt
Possible Cause
User did not lower throttle
trim and throttle stick
prior to initializing the
aircraft
Throttle channel is
reversed. Futaba transmit-
ters (equipped with
Spektrum modules) may
require you to reverse the
throttle channel
User did not wait at least
5 seconds after powering
the transmitter prior to
connecting the flight
battery to the aircraft
User bound the aircraft to
a different transmitter
Transmitter was too close
to aircraft during the
initialization process
User did not initially set
up transmitter prior to
binding to the aircraft
User may have acciden-
tally plugged the flight
battery in with the wrong
polarity
23
Solution
Lower throttle stick and
throttle trim to their lowest
settings
Reverse throttle channel on
specific transmitter if
applicable
Unplug, then reconnect
flight battery
Rebind aircraft to your
desired compatible
transmitter
Move transmitter (powered
on) a few feet from the
aircraft prior to reconnecting
the flight battery
See the "Advanced
Programming" section of
this manual
Replace AR7110/AR7110R
board and ensure the RED
polarity marks are facing the
same direction when
connecting the flight battery
to the AR7110/AR7110R
board
EN