Spektrum AR7110 Bedienungsanleitung Seite 11

Bracket adjusted for 90-size engine
• Plug the servo leads and rpm sensor into the appropriate ports in the receiver.
• You are now ready to bind the system.
Note: In order for the system to operate, one remote receiver must be plugged into
receiver port B or R.
Connections
The throttle and gear channels have two outputs. Output 1 is unregulated and the
pack voltage is provided at this port. Throttle and Gear outputs 2 are regulated to
5.2 volts when a throttle servo and gyro are used that are not compatible with high
voltage. Most gyros require less than 6 volts.
Binding Telemetry with PowerSafe Receivers
Spektrum PowerSafe receivers like the AR9110, AR12110 and the AR7110 require
a special binding procedure when using telemetry modules.
1. Insert a bind plug in the bind port in the receiver.
2. Insert the telemetry modules' Data port lead into any un-used channel in the
receiver. (If all channels are being used remove any servo lead from the receiver
to allow an open servo port to be accessed).
Bracket adjusted for 50-size engine
11
EN