Spektrum AR7110 Bedienungsanleitung Seite 12

EN
3. Power the receiver through the EC3 connector. Note all of the receivers
(internal and remote) should be flashing indicating they are in bind mode.
4. Using a second battery, insert the battery plug into any un-used channel in the
receiver while pressing and holding the bind button on the side of the telemetry
module. This will place the telemetry module in bind mode.
5. Make sure that the LEDs are flashing on all receivers and on the telemetry
module. Place the all channels (sticks and switches) on the transmitter in the
desired failsafe position. Now bind the transmitter to the system.
6. Remove the second battery from the receiver, remove the bind plug and move
the telemetry module connector to the bind port to allow flight log data to be
displayed.
NOTICE: Do not leave the secondary battery plugged in for more than a few
minutes as damage to the battery can occur.
Optional Charge ON/OFF Adaptor Lead
Included with the system is an optional charge, ON/OFF adaptor lead. Some heli
pilots may prefer to use this adaptor lead instead of the included Soft Switch. When
plugged into the receiver' s switch port this adaptor lead allows the following:
• The battery can be charged through the adaptor lead.
• The system can be turned off by inserting the bind plug. Removing the bind plug
turns the system on.
• Battery voltage can be monitored through the adaptor lead using a Flight Log
or voltmeter. If the voltmeter is plugged directly into the male-male extension,
the system is active and voltage under load (system operational) is displayed. If
plugged into the charging lead, the at-rest battery voltage is displayed.
Install the adaptor lead as shown:
12