Technical Data - piezosystemjena NV40/3 Bedienungsanleitung

8.4 technical data

number of channels
output power
output voltage
output current (continuous)
noise of output voltage
modulation input (MOD)
input impedance
manually control
display
output connector
monitor output (MON)
NV40/3CLE, NV120/1CLE
selectable
monitor output (MON)
NV40/3, NV120/1
closed loop control
dimensions w x h x l
mass
interface
converter resolution
features
main power supply
order info
Geschäftsführer: Dr. Bernt Götz • Telefon 03641/66880 • Fax 03641/668866 • www.piezosystem.com
46
NV40/3 [CLE]
3x 5W
3x 40mA
TFT full colour graphic, 320x240 Pixel
3x D-SUB15pin
D-SUB25pin, output impedance <100Ω
-13 to +13V measuring system voltage (open loop)
0 to +10V measuring system voltage (closed loop)
D-SUB25pin, output impedance <100Ω
0 to +10V (equates to actuator voltage -20 to +130V)
PID analogue, switched on/off by pushing the encoder
()
soft start function, ASI function, over voltage protection,
over temperature protection, short circuit proof,
(wide range power supply 100-240VAC is included in
chart 5: technical data NV40/3 [CLE], NV120/1 [CLE]
3
-20V to +130V
<0,3mV @ 500 Hz
RMS
0V to +10V, D-SUB25pin
10 kΩ
digital encoder
knob,
for CAP und SG sensors
210mm x 88mm x 240mm
2,1kg
RS232 D-SUB9pin, USB 1.1
16 bit
dimmable display
24VDC / 2,5A
the shipment)
NV40/3 – E-101-20
NV40/3CLE – E-101-23
NV120/1 – E-101-90
NV120/1CLE – E-101-93
NV120/1 [CLE]
1
15W
120mA
D-SUB15pin