Technical Data - piezosystemjena 30DV50 Bedienungsanleitung

8.3.1 technical data

Input voltage:
Power supply connector:
Input current:
Power consumption:
Output power:
Output voltages:
Output current (constant current):
Output noise:
Actuator / measurement connector „PIEZO": 15pin D-Sub plug
Monitor output:
Monitor output impedance:
Modulation input:
Modulation input impedance:
Trigger output (low-active)
MOD - MON connector „ANALOG":
Offset voltage:
Safety functions:
Display (LED):
Interface
Interface connector
Cooling
Dimensions (W H D):
Weight:
Geschäftsführer: Dr. Bernt Götz • Telefon 03641/66880 • Fax 03641/668866 • www.piezosystem.com
10 – 30 VDC
low voltage socket with 2.1mm-pin
max. 2.5A @ 10V
max. 1.0A @ 30V
max. 30W
7.5W (max. 15W for nanoX
-20V...+130V
+130V...-20V for nanoX
50mA permanently
TM
(2x 50mA for nanoX
<0.3mV @ 500Hz
RMS
0 ... +10V (programmable signal source)
1kΩ
0 ... +10V (disconnectable)
25kΩ
5V/0V with pull-up-drain resistor 240
9pin D-Sub socket
-20V ... +130V via encoder
short circuit proof, temperature fuse
green / yellow
green = in operation / open loop
yellow = closed loop
OVL (yellow) = overload
UDL (yellow) = underload
RS232
9pin D-Sub socket
Fan, temperature controlled
(130 x 86 x 230) mm
1.6kg
TM
actuators)
TM
actuators
actuators)
Ω
table 1: technical data
47