Kärcher HD 5/11 E Classic Bedienungsanleitung Seite 15

Maintenance intervals
Each time before use
1. Check the power cable for damage and have a dam-
aged cable replaced immediately by the authorised
Customer Service or a qualified electrician.
2. Check the high-pressure hose for damage and re-
place a damaged high-pressure hose immediately.
3. Check the device for leaks. 3 drops of water per min-
ute are permissible. Contact Customer Service in
the case of more serious leaks.
Weekly
1. Clean the water filter, see Chapter Cleaning the wa-
ter filter.
Every 500 operating hours, at least once annually
Have the oil changed by Customer Service.
Maintenance work
Cleaning the water filter
ATTENTION
Damaged water filter in the water connection
Damage to the device through contaminated water
Fault
Device does not start
Device not building up
pressure
Pump leaking
Up to 3 drops of water per
minute are permissible.
Pump knocking
Warranty
The warranty conditions issued by our sales company
responsible apply in all countries. We shall remedy pos-
sible malfunctions on your device within the warranty
period free of cost, provided that a material or manufac-
Electrical connection
Voltage
Phase
Frequency
Power rating
Degree of protection
Power protection (slow-blowing)
Extension cable, 30 m
Remedy
 Check the power cable for damage.
 Check the mains voltage.
 If the device overheats:
a Set the power switch to "0".
b Allow the device to cool for at least 15 minutes.
c Set the power switch to "1".
 Contact Customer Service in case of electrical faults.
 Fit the standard nozzle (size specified, see Chapter Technical data).
 Clean / replace the high-pressure nozzle.
 Vent the device (see Chapter Venting the device).
 Clean the water filter (see Chapter Cleaning the water filter).
 Clean all inlet pipes to the pump.
 Check the water supply volume (see Chapter Technical data).
 In case of more serious leaks, have the device checked by Customer Service.
 Clean the water filter.
 Check the water supply line for leaks.
 Vent the device (see Chapter Venting the device).
 Contact Customer Service if necessary.
Technical data
Check the water filter for damage before inserting it into
the water connection.
1. Pull the water filter out.
2. Clean the water filter under running water.
3. Re-insert the water filter into the water connection.
Troubleshooting guide
DANGER
Risk of injury due to inadvertently starting up de-
vice and also due to electric shock.
Switch off the device immediately and unplug the mains
plug before performing work.
Have electrical components checked and repaired by
the authorised Customer Service.
In case of any malfunctions not mentioned in this chap-
ter, contact the authorised Customer Service when in
doubt or when you have been explicitly advised to do
so.
turing defect is the cause. In a warranty case, please
contact your dealer (with the purchase receipt) or the
next authorised customer service site.
(See overleaf for the address)
HD 5/11 E Classic
V 220 - 240
~ 1
Hz 50
kW 2.2
IPX5
A 15
2
mm 2.5
English
HD 5/11 EX Plus
Classic
220 - 240
1
50
2.2
IPX5
15
2.5
15