Herunterladen Diese Seite drucken

Kärcher HD 5/13 P Bedienungsanleitung Seite 16

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
Before each use
 Check connection cable for damages
(risk of electrical shock); get the dam-
aged connection cable replaced imme-
diately by an authorised customer ser-
vice person/ electrician.
 Check the high pressure hose for dam-
ages (risk of bursting).
Please arrange for the immediate ex-
change of a damaged high-pressure
hose.
 Check appliance (pump) for leaks.
3 drops per minute are permitted and
can come out from the lower side of the
appliance. Call Customer Service if
there is heavy leakage.
 Clean the sieve in the water connection.
Clean the sieve in the water connection
 Take out sieve.
 Clean the sieve from the outside and
rinse it.
 Insert sieve.
Every 500 operating hours, at least
 Have the maintenance of the device
performed by the customer service.
Troubleshooting
DANGER
Risk of injury by inadvertent startup of ap-
pliance and electrical shock.
– Prior to all work on the appliance,
switch off the appliance and pull the
power plug.
– Get the electrical components checked
and repaired only by authorised cus-
tomer service persons.
– Contact an authorised customer service
person in case of problems not men-
tioned in this chapter or if you are in
doubt or when you have been explicitly
asked to do so.
16
Weekly
annually
Appliance is not running
 Check connection cable for damages.
 Check the supply voltage.
 If the appliance is overheated:
Set the appliance switch to "0".
Allow machine to cool down at least for
15 minutes.
Set the appliance switch to "1".
 Call Customer Service in case of elec-
trical defects.
Pressure does not build up in the
 Check the nozzle size, install correct
nozzle.
 Deaerate the appliance (see "Start-up")
 Clean the sieve in the water connection.
 Check water supply level (refer to tech-
nical data).
 Clean the nozzle.
 Replace the nozzle.
 Contact Customer Service if needed.
3 drops of water per minute are permitted
and can leak from the bottom of the appli-
ance.
 With stronger leak, have device
checked by customer service.
Pump is vibrating
 Check the water suction pipe for leaks.
 Deaerate the appliance (see "Start-up")
 Contact Customer Service if needed.
Accessories and Spare Parts
Only use original accessories and spare
parts, they ensure the safe and trouble-free
operation of the device.
For information about accessories and
spare parts, please visit www.kaerch-
er.com.
– 6
EN
appliance
Pump leaky

Werbung

loading