AC Schnitzer 5111 287 310 Montageanleitung Seite 23

F it t in g In s t r u c t io n s
AC Schnitzer Front Splitter M2
2. Fitting the AC Schnitzer Front Splitter
Remove the standard front skirt.
To do this...
Fig. 10
Unscrew fixing bolts (1) inside the wheelarch and
standard front skirt (2) from the top. If necessary, re-
move wheelarch lining fully.
Fig. 11
Remove engine bay seal on standard front skirt and
release the fixing bolts (1) underneath.
Remove the wiring harness of the signal horn and
temperature signal. Disconnect and then close the
hose connector of the headlight washing system.
Remove the standard front skirt from the vehicle by
pulling forwards.
Fitting Note:
On fitting, ensure that the clips (2) thread correctly
back into the standard front skirt!
Fig. 12
Remove lower front guide (1) for standard front skirt.
To do this, release two fixing screws (2).
The guide for the standard front skirt is not re-used.
AC Schnitzer - automobile Technik - Neuenhofstraße 160 - D - 52078 Aachen - Tel. 0241/5688 -130
Fitting Instructions No.: 5111 287 310 / Issue: 12.07.2017 / TSch / REV02
2
2
23
1
2
1
Fax -135
1