OSOTEK HotWave Bedienungsanleitung Seite 8

Installing the Base Station
1. Place the base station against a wall, and connect the power cord to it. Store
the power cord in the back of the base station.
Note:
Do not place the vacuum and the base station near heat sources or in humid
areas, such as by a radiator, in a kitchen, or in a bathroom.
2. Press and hold the release button on the water tank cover and simultaneously
rotate the cover to open it. Then add clean tap water to the water tank and
install the cover back. It is secured in place when you hear a click.
Notes:
• Please use the special cleaning solution for this product and inject it into the
base station water tank with reference to the standard dilution ratio of the
cleaning solution.
• It is forbidden to add any liquid other than tap water and original cleaning
solution to avoid danger.
Click into Place
7