OSOTEK HotWave Bedienungsanleitung Seite 11

Using Scenarios
The vacuum can be used to clean different types of hard-surface flooring such as
wood, tile, and marble.
• When the vacuum is working, the number on the display represents the
temperature of water in the clean water tank.
• After adding hot water to the vacuum, the temperature of the water in the
clean water tank may be different from the temperature of the roller brushbar
surface. This is affected by the factors including operating environment, the
temperature of water in the base station's water tank, the flooring material, and
the heat loss in water pipelines.
Do not use the vacuum on fabric surfaces, such as carpets and blankets.
Water Adding
• When the vacuum is placed on the base station, the room temperature mode
will be enabled and the base station will automatically add room temperature
water to the vacuum.
• Press the button
the base station will first pump the low-temperature water out of the vacuum,
and then start to add high-temperature water to it.
• Do not remove the vacuum from the base station during water adding. Press
the button
• The water tank indicator will change its color based on the water level. White
indicates sufficient water, yellow indicates low water level, and red indicates
insufficient water.
Notes:
• Due to the nature of the heating components, the first two heating temperatures may be a
little lower. The water will be heated properly afterward.
• When heating water, the base station may make a sound similar to boiling water, which is
normal.
✖
10
to enable the high-temp mode. Once this mode is enabled,
or to stop adding water.