OSOTEK HotWave Bedienungsanleitung Seite 10

Charging
Battery Level Display
1. Place the vacuum on the base station, and the vacuum will begin charging. The
display will go out 20 seconds after the vacuum is fully charged.
2. The number on the display represents the current battery level in a percentage
during charging. The display will go out 20 seconds after charging is completed.
3. The vacuum cannot be charged when it is in the process of water adding, self-
cleaning, or drying.
How to Use
Display and Buttons Instructions
Water Absorbing
Mode
Battery Capacity
Indicator
Water Adding
Indicator
Turbo Mode
Auto Mode
High-temp Mode
Temperature Indicator
Self-cleaning Mode
Error Status
Dirty Sensing/Working
Status/Error Status
Indicator
9
Self-cleaning Button
• Press to start self-cleaning and drying.
Hot Water Adding Button
• Press to start adding hot water.
When adding hot water, the base station will first
pump the low-temperature water out of the vacuum,
and then start to add high-temperature water to it.
Mode Switch Button
• Cycle through the modes when the vacuum is on.
Power Button
• Press and hold to turn on/off the vacuum.
Voice Control Button
1. Short press this button to turn on/off the voice alerts
or adjust the volume:
Press this button to switch from voice alerts on
(default) - low volume - to voice alerts off cyclically;
2. Press & hold, and then short press this button to
change the language:
Press and hold this button for 3s to broadcast voice
alerts in the current language, that is, enabling
the language switch. Then, if no operations are
performed within 5s, the current language will be
still used; If you press the voice control button within
5s, the language will be switched to the next one. If
you perform no operation within 5s after that, the
switched language will be used, and so on.