STEINEL PROFESSIONAL HF 3360 KNX Information Seite 10

A microprocessor then issues the switch command "switch light ON".
Detection is possible through doors, panes of glass or thin walls.
Optionally, all function settings can be made via the RC6, RC7 remote controls as
well as the Smart Remote. (➔ "7� Accessories")
Package contents for surface-mounted installation (Fig� 3�1)
Package contents for concealed installation (Fig� 3�2)
Product components (Fig� 3�3)
A Status LED
B Programming button
C Load module, power supply lead, surface-mounted
D Load module, power supply lead, concealed
E Designer trim, round or square
F Sensor module
Product dimensions
Ceiling / wall mounting, surface-mounted and concealed wiring (Fig� 3�4)
4� Installation
Wiring diagram (Fig� 4�1)
An optional corner wall mount is available for mounting the HF 3360 KNX.
(Prod. no. 648114 white).
– Surface-mounted installation
If the rubber seal is damaged, the cable entry openings must be sealed with an M16
or M20 (at least IP54) double seal cable gland.
For mounting on the wall, a condensation water drainage hole (Ø 5 mm drill bit) is
marked next to the rubber seal. This must be opened if necessary. (Fig� 5�4)
18
5� Mounting
• Check all components for damage.
• Do not use the product if it is damaged.
Installation procedure
Wall-mounting, concealed power supply lead (Fig� 5�1)
Ceiling mounting, concealed power supply lead (Fig� 5�2)
Ceiling mounting, surface-mounted power supply lead (Fig� 5�3)
Wall-mounting, surface-mounted power supply lead (Fig� 5�4)
• Detach designer trim from sensor module.
• Disconnect sensor module from the load module.
Concealed mounting (Fig� 5�1 / 5�2)
• Make plug connection.
• Press the programming button (B).
• Insert fastening screw and mount load module
• Make settings. (➔ 6� Functions and settings)
Surface mounting (Fig� 5�3 / 5�4)
• Insert fastening screw and mount load module
• Make plug connection.
• Press the programming button (B).
• Make settings. (➔ 6� Functions and settings)
• Fit sensor and load module together and screw into place.
• Fit designer trim.
Reach diagram (Fig� 5�5)
6� Functions/settings
You will find an application description at knx�steinel�de
Functions to be used are selected from the "General Settings" parameter window
using the Engineering Tool Software (ETS) from version ETS4.0.
1. Issue physical address and generate application program in the ETS.
2. Load the physical address and application program into the motion detector.
When you are prompted, press programming button B.
3. The red LED goes out once programming has been successfully completed.
19