Werbung
Safety and operating instructions
1. Place the cap over the hexagon body of the
insertion tool.
2. Place the buffer (A) over the stem of the insertion
tool.
3. Insert the insertion tool into the cylinder and
screw the cap onto the cylinder until it is locked.
Operation
WARNING Involuntary start
Involuntary start of the machine may cause injury.
Keep your hands away from the start and stop
►
device until you are ready to start the machine.
►
Learn how the machine is switched off in the event
of an emergency.
Stop the machine immediately in all cases of
►
power supply interruption.
Start and stop
Start the machine by squeezing the trigger while
firmly holding the handle.
Stop the machine by releasing the trigger. The trigger
returns automatically to the stop position.
16
A
© 2012 Atlas Copco Construction Tools AB | No. 9800 0653 90e | 2012-10-22
Operating
Starting a cut
Stand in a stable position with your feet well away
♦
from the inserted tool.
Press the machine against the working surface
♦
before you start.
Start collaring at such a distance from the edge
♦
that the machine is capable of breaking the
material without levering.
Never try to break off too large pieces. Adjust the
♦
breaking distance (A) so that the inserted tool does
not get stuck.
Breaking
Let the machine do the work; do not press too
♦
hard. The vibration-absorbing handle must
absolutely not be pressed all the way down to the
base.
♦
For pneumatic machines with vibration-absorbing
handles: The feed force should be adapted so that
the handle is pressed down 'half way'. The best
vibration damping and breaking effect is achieved
at this position.
Avoid working in extremely hard materials for
♦
example granite and reinforcing iron (re-bar) which
would cause substantial vibrations.
TEX 07PE
A
Min
A
Max
Original instructions
Werbung
