Extremis hopper Gebrauchsanweisung Seite 15

4. Put the tabletop with its frame facing
downwards on top of the two boards. The
top of the table legs is now at the same
height as the tabletop.
A
5. In case of steel legs (A), put 3 carriage
bolts through the square holes of each table
leg. In case of aluminium legs (B), the
threaded rods are already attached to the
6. Before assembling the benches, remove
the packaging material from under the
frame!
B
table legs. Move the table legs towards the
table frame until the 3 threaded rods fit into
the 3 holes in the coupling piece. Screw the
supplied nuts and lock washers onto the
threaded rods, but do not tighten them yet.
15
english