SystemAir SAVE VTR 250/B Betriebs- Und Wartungsanleitung Seite 13

GB
Note:
The drainage connection is plugged in the bottom of the unit at delivery. To use the drainage: remove the
rubber seal and connect the water hose. Connect the water hose to the sewer. The water can not be led
straight to the sewer without a water trap.
6.5 Open the front hatch
The front hatch is mounted with hinges. Hinges to the right on an L model and to the left on an R model.
Open the hatch with the two latches and swing the hatch open.
7 Configuration
7.1 General
SAVE VTR 250/B has a modern touchscreen LCD control panel, simply known as HMI — Human Machine Interface. The
touchscreen display provides information about current state of the unit and allows you to control all system functions.
Settings are done by touching the icons or options. The touch screen is sensitive and it is not necessary to press too
hard.
7.2 Startup wizard
During the first power up of the unit, you will be asked to set:
• menu language
• time and date
• airflow control type (Manual/RPM) and airflow level values
• heater type (None/Electrical/Water/Change-over)
If the start-up wizard is cancelled it will start again during next power up of the unit, this will continue until start-up wiz-
ard is successfully finished.
7.3 Common symbols
The following selection symbols are common and are present in most menu pages:
Back button to return to a previous
menu, located at the upper left corner
Up arrow to increase a value
Down arrow to decrease a value
Some menus have more than one page. Touch page indicator in the top right corner to go to the next page. The first
number indicates current page number and the second number indicates a total number of pages available.
Many options show up in a form of the pop-up window. Select the option from the displayed list in the pop-up window
and press OK to confirm selection.
211473 | B003
On and Off slider to activate or
deactivate a function. White bubble —
function is inactive, green bubble —
function is active.
Button to cancel changes
CANCEL
Buttons to confirm changes
SET/OK
13
Configuration |