SystemAir SAVE VTR 250/B Betriebs- Und Wartungsanleitung Seite 12

12
| Installation
6 Installation
This section describes how to install the unit correctly. To ensure a proper and fail-free operation, it is important that
the unit is installed according to these instructions.
6.1 Unpacking
Verify that all ordered equipment are delivered before starting the installation. Any discrepancies from the ordered
equipment must be reported to the supplier of Systemair products.
6.2 Where/how to install
The SAVE VTR 250/B can be installed in any room in the household.
6.3 Installation procedure
1 Prepare the surface where the unit is to be mounted.
Make sure that the surface is flat, vertical and that it
supports the weight of the unit. Perform the installa-
tion in accordance with local rules and regulations.
2 Fit the mounting bracket (pos. 1) with the anti-vibra-
tion pad (pos. 2) to the wall with enclosed screws.
Use appropriate holes to screw the bracket firmly to
the wall. Bottom side of bracket should be 40 mm (H)
below top of unit position.
Note:
Make sure that the mounting bracket is
completely horizontal once mounted on
the wall. Check with a spirit level.
3 Lift the unit in place
Warning
Beware of sharp edges during mounting
and maintenance. Use protective gloves.
Consider the unit weight when mounting!
Note:
Make sure that the unit is completely
vertical and horizontal once mounted on
the wall. Check with a spirit level.
4 Connect the unit to the duct system. Make sure that
all necessary accessories are used to create a func-
tional ventilation solution.
Warning
The installation of the unit and complete
ventilation system must be performed by
an authorized installer and in accordance
with local rules and regulations.
5 Connect the unit electrically to the mains with the en-
closed plug and check that it starts up correctly.
6.4 Condensation drainage
In general no condensation drainage is needed for rotational heat exchangers at dry conditions. However, if a lot of hu-
mid air is present in the residence, a condensation drainage might be needed. Drainage connection is available as an ac-
cessory and can be ordered separate.
GB
211473 | B003