SystemAir SAVE VTR 150/B L 500W Wartungsanleitung Seite 77

64 | Accessories
• DP — diverting plug
• HMI — control panel
Component/product — Article number:
• CE/CD-diverting plug 4pin — 37367
• CEC Cable w/plug 12m — 24782
• CEC Cable w/plug 6m — 24783
• HMI White — 138077
• HMI Black — 138078
Installation and connection
1. Connect diverting plug to the connection box socket dedicated for external control panel (HMI) or Internet access
module (IAM).
2. Plug in control panels to diverting plug(s) using recommended cables or any cable with RJ22 type plugs.
Note:
The maximum supported cable length is 50 meters.
Configuration
1. Go to Service menu
2. Enter password (default 1111)
3. Go to Communication ⇒ HMI Address and change the address number. Repeat these steps for each connected
control panel.
Each control panel must have it's own unique address number. No control panel should have the same address value
to function properly.
11.5.4 Presence detector
A presence detector is used to activate one of required functions when someone is present in the room.
Universal input can be easily re-configured to activate a different function.
Component/product — Article number:
• Presence detector/IR24 — 6995
Configuration
1. Go to Service menu
2. Enter password (default 1111)
3. Go to Input menu. Select UNIVERSAL tab.
4. Select the universal input to which wire from the pres-
ence detector is connected.
If, for example, it is connected to UI3 on the connection
board, then select UNIVERSAL INPUT 3. Set signal
type as Digital Input and select your desired
function.
Any movement in the motion sensor working area will activate your selected function.
11.5.5 Push button
A push button is a simple mechanical button which can be used to activate one of many available functions.
Universal input can be easily re-configured to activate a different function.
Component/product — Article number:
• Push button — 9693
GB
212024 | A003, rev 29