Werbung
Verfügbare Sprachen
Verfügbare Sprachen
-
An excessive and early stretch of the PINLOCK
sive adherence against the visor surface and/or permanent deformations with
subsequent inability to correctly perform any following adjustments.
-
Intense sweating /breathing, the use under particular weather conditions (low
temperatures, and/or high humidity and/or sudden changes in temperature and/
or heavy rain) and/or intense and prolonged use may affect the performance of
the PINLOCK
such cases, after using the helmet and to restore the system efficiency, remove
the PINLOCK
air. The same procedure must be applied to the helmet, in order to dry out humid-
ity in case it has formed up as a consequence of the conditions described above.
10. Inner Visor PINLOCK
10.1. Remove the visor equipped with the Pinlock
above).
10.2. Widen the visor and release the Pinlock
10.3. Release the visor.
Maintenance and Cleaning
-
Remove the PINLOCK
gently clean it with neutral liquid soap. Remove the soap under running water.
-
Dry the inner visor with dry and warm air without wiping it.
-
To keep the features of the inner visor in good conditions over time, let the helmet
dry in a ventilated and dry place with the visor open after use. Keep it away from
heat sources and store it in a place away from direct light.
-
Do not use solvents or chemical products.
SIDE PLATES
When the helmet N40
assembled in its place.
11. Side Plates Assembly
To assemble the side plates first remove the lateral latches and (if assembled) the
peak and the visor (see instructions above).
11.1. Place the left side plate on the corresponding side mechanism centring its hole
on the mechanism and its teeth (Fig. 16).
11.2. If you wish to assemble the peak above the plates see the relevant installation
instructions.
11.3. Assemble the left lateral latch as indicated in the instructions above.
11.4. Follow the same steps on the right side of the helmet.
12. Side Plates Disassembly
To disassemble the side plates first remove the lateral latches and (if assembled) the
peak (see instructions above).
Then remove the plates from the side mechanisms.
Next, reassemble the visor and then the peak (if any) as explained in the previous
instructions.
WARNING
-
When using the helmet in a configuration without the visor, always assemble the
lateral latches and the side plates.
inner visor and cause fogging or formation of condensation. In
®
inner visor from the helmet visor and let it dry with dry and warm
®
Disassembly
®
inner visor from the visor. Using a damp and soft cloth,
®
GT is configured without the visor the side plates must be
5
inner visor may result in exces-
®
inner visor (see instructions
®
inner visor from the pins (Fig. 13).
®
20
Werbung
