Werbung
Verfügbare Sprachen
Verfügbare Sprachen
INSTRUCTIONS FOR USE
The N40
GT helmet can be used in 8 different configurations. It features three
5
elements (visor, removable protective chin guard and peak) which can be as-
sembled on the product jointly, in pairs, separately or be removed altogether
(Fig. 1).
Using the helmet in the configurations featuring the chin guard fastened and
visor pulled down definitely guarantees a higher level of protection if compared
with the other possible configurations.
The chin guard locking slot covers - which have to be assembled if the helmet is
used without chin guard - are included in the box.
Peak and side plates - which have to be assembled if the helmet is used without
visor - are available on the product itself, in the box or otherwise as accessory /
spare parts - depending on the version of the product.
LATERAL LATCHES
1.
Lateral Latches Disassembly
1.1 Release the left safety cover from its lateral latch pulling it outwards - without
removing it (Fig. 2A).
WARNING: pulling excessively the cover while releasing it from the latch
may cause damage to the cover or to the latch.
1.2. Turn the latch with the cover released upwards (Fig. 2B).
1.3. Remove the latch with the cover from the helmet by pulling it outwards so that
the latch inner bayonets "A" come out of their housing in the side mechanism
(see Fig. 3).
1.4. Follow the same steps on the right side of the helmet.
2.
Lateral Latches Assembly
2.1. Place the left side latch with its cover on the visor mechanism and insert the inner
bayonets "A" in their special housing in the side mechanism (Fig. 3).
2.2. Rotate the latch with its cover towards the rear part of the helmet (Fig. 2B). Fix
the latch by positioning the safety cover (Fig. 2A). Make sure the cover is firmly
attached to the latch.
2.3. Follow the same steps on the right side of the helmet.
WARNING
-
Always ensure that the latches and the safety covers have been correctly assem-
bled and that they grip well to the side mechanisms.
-
If your configuration of the helmet includes the visor and/or the peak try to acti-
vate them (see instructions below) and check that the latches remain still in their
position.
-
Regardless of the configuration and accessories assembled on the helmet, never
use the helmet without having assembled the lateral latches correctly.
-
Never remove the side mechanisms from the shell.
-
Should any of the side mechanisms fail or be damaged, please refer to a Nolan
authorized dealer.
PEAK
(Available as standard or accessory/spare part).
The peak can be assembled over the visor or, in absence of the latter, over the side
plates.
16
Werbung
