Werbung
Verfügbare Sprachen
Verfügbare Sprachen
8.3. Insert the right and left chin guard ends simultaneously into the slots on the
corresponding side frames of the helmet and press the chin guard towards the
inside of the helmet until you hear the fastening click on both sides (Fig. 12).
8.4. Make sure the chin guard is correctly fastened at both ends by gently pulling it
towards the outside of the helmet.
WARNING
-
Never remove or disassemble the semi-rigid inner padding of the protective chin
guard.
-
When the helmet is used without the removable protective chin guard, always
assemble the chin guard covers supplied.
-
If in doubt on how the manual chin guard release device works, please contact a
Nolan dealer.
(Available as standard or accessory/spare part).
9.
Inner Visor PINLOCK
9.1. Disassemble the visor (see instructions above).
9.2. Make sure that the inner surface of the visor is clean and check that the pin ad-
justment external levers are turned inwards (Fig. 13).
9.3. Place the PINLOCK
WARNING: The silicone-sealed profile of the PINLOCK
contact with the inner surface of the visor.
9.4. Insert one side of the PINLOCK
in position (Fig. 14).
9.5. Widen the visor and fasten the other side of the PINLOCK
second pin (Fig. 15).
9.6. Release the visor.
9.7. Remove the protective film from the PINLOCK
entire silicone-sealed profile of the inner visor adheres to the visor.
9.8. Fit the visor on the helmet (see instructions above).
Checking and Adjusting the PINLOCK
Check the correct PINLOCK
and making sure that they do not move.
If the PINLOCK
inner visor is not tightly fixed to the visor, move both external adjust-
®
ment levers upwards to increase the stretch (Fig. 14). This operation must be carried
out gradually. The maximum stretch is achieved when the pin adjustment external
levers are turned outwards.
WARNING
-
The presence of dust between the two visors may produce scratches on both
surfaces.
-
Scratched PINLOCK
must therefore be replaced.
-
Regularly check the correct stretch of the PINLOCK
from moving and scratching both surfaces.
-
If the helmet visor fogs up and/or condensation forms between the visors, check
that the PINLOCK
Assembly
®
inner visor on the visor.
®
inner visor on one of the visor pins and hold it
®
inner visor assembly by opening and closing the visor
®
visors and inner visors may cause reduced visibility and
®
inner visor is both correctly assembled and stretched.
®
inner visor and check that the
®
Inner Visor Stretch
®
inner visor to prevent the it
®
19
inner visor must be in
®
inner visor to the
®
Werbung
