Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2.10 Cancel all pr ogramming/all fingers
If you want to cancel all the data in the fitting, it is reset to installation mode (Chap. 1.4 on page 45).
Caution
Access by unauthorised persons is possible! There is a security leak here.
Read in the new master finger immediately!
If you want to leave the fitting in the original installation state, this can be activated with any finger.
If you delete all programming entries, then:
All user fingers are cancelled.
The cancel finger is cancelled.
The master finger is cancelled.
The security fitting will be activated.
The fitting can be switched back and forth between connecteded and deactivated with any finger (installation
mode).
Cancelling all information from the memory of the security fitting
1. Begin cancel operation:
beep......... flashing
beep......... flashing
2. Carry out cancellation operation:
beep
beep flashes 4x
D00445
08
All manuals and user guides at all-guides.com
Draw your master finger over the sensor
You will hear an audible signal.
and
Draw your master finger over the sensor
You will hear an audible signal.
and
Draw your master finger over the sensor
You will hear an audible signal.
flashes for a few seconds.
flashes
Draw your master finger over the sensor
You will hear an audible signal.
flashes 4 times.
Programming instructions
flashing alternately for a few seconds.
flashing alternately for a few seconds.
Seite 61
Werbung
