Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Sicherheitsbeschlag mit integrierter Zutrittskontrolle
2.6.1 Assigning retrospective authorisation for permanent release
You can assign retrospective authorisation for permanent release to a user finger that is already stored.
1. Start the programming:
beep......... flashing
beep......... flashing
2. Read in user finger:
beep lights up flashes 2x
Now authorisation for permanent release has been assigned.
You can read how to switch on permanent release in Chap.4.2.3 from page 65.
2.6.2 Blocking authorisation for permanent release
To block authorisation for permanent release, cancel the corresponding user finger as described in Chap. 2.7.1 on
Page 57.
The user finger and the associated substitute user finger are then cancelled.
In order to be able to operate the fitting you must read in a new user finger and if applicable a new substitute user
finger.
You can read how to read in a user finger in Chap. 2.6 on Page 54.
Seite 56
All manuals and user guides at all-guides.com
Draw your master finger over the sensor
You will hear an audible signal.
and
flashing alternately for a few seconds.
Draw your master finger over the sensor
You will hear an audible signal.
and
flashing alternately for a few seconds.
You're your user finger over the sensor
You will hear an audible signal.
lights up.
( flashes 2x.
D00445
08
Werbung
