Werbung
Verfügbare Sprachen
Verfügbare Sprachen
After use, there would be a little food left in the grinder head. This is normal. There might be a bit of
black metal powder adhering to the food ground in the end. Please pick them out and throw away,
do not eat them.
To avoid jamming, do not force to operate the unit with excessive pressure.
When the circuit breaker activates, do not switch on.
Never try to replace the parts and repair the unit by yourself.
This appliance is not intended for use by persons(including children) with reduce physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a person responsible for their safety.
If the supply cord is damaged,it must be replaced by the manufacturer or its service agent or a
similarly qualified person in order to avoid a hazard.
Children should be supervised to ensure that they do not play with the appliance.
Check that voltage indicated on the rating label corresponds the mains voltage in your home.
Wash all parts (except body) in warm soapy water.
Before plugging in, ensure the "ON/0/ R" switch is turned to "O" position.
ASSEMBLING
Holding the head, insert it in the inlet
(fig.1). Rotate the head in the same
direction as fig.2 until a small sound can
be heard. The head has been placed in
the inlet. Try to rock the head slightly to
ensure it is placed well.
Place the feed screw into the head, long
end first, by turning the feed screw
slightly until it is set into the motor
housing (fig.3).
Place the cutting blade onto the feed
screw shaft with the blade facing the
front as illustrated (fig.4). If it is not
fitted properly, meat will not be ground.
Place the desired cutting plate next to
the cutting blade, fitting protrusions in
the slots (fig.5).
Support or press the centre of the cutting
plate with one finger then screw the
fixing ring until tight with another hand
(fig.6). Do not over tighten.
Place the hopper plate on the head and
fix into position.
Locate the unit on a firm place.
The air passage at the bottom and the
side of the motor housing should be kept free and not blocked.
FOR THE FIRST TIME
INSTRUCTION FOR USE
Werbung
