Christopeit Sport ET6 Montage- Und Bedienungsanleitung Seite 20

Step 4:
Attach the handlebar post (4) at mainrame (1).
1. Remove the pre-assembled 6 Allen head bolt (17), 4 washers (19), 2
washers (41) and 6 spring washers (18) rom main rame (1).
2. Attach the ront post (4) to the ront post mounting tube o main rame
(1) and connect the plug o control cable (21) to the socket o the con-
nection cable (22).
3. Insert the ront post (4) to mainrame (1) and secure, using 6 Allen head
bolts (17), 6 spring washers (18), 2 washers (41) and 4 washers (19).
Step 5:
Attach the computer (8) at handlebar post (4).
1. Remove the screws (27) to x the computer rom backside o computer
(8).
2. Put in the plug o connection cable (22) into the socket rom computers
(8) backside.
3. Attach the computer (8) on top o handlebar post (4) with and tighten
with screws (27). (Attention: Ensure that the cable loom are not crunched
or pinched during installation.)
Step 6:
Attach the handlebar (5).
1. Attach the handlebar (5) to the welded clamp o ront post (4) and secure
with clamp rst. Then put on the decoration cover (23a) and a washer
and the handlebar grip screw (25) to tighten the handlebar (5) rmly.
Fix the decoration cap (23a) with screw (24).
2. Insert the plug o hand pulse wire (28) to the jack o the computer (8).
Attach the handlebar cover (23b) with screws (24+26).
3. Plug the mains cable (40) into the mains connection socket (75) and
into a properly connected socket (230V ~ 50Hz). Then switch on the
main switch (76).
Step 7:
Checks
1.
Check the correct installation and unction o all screwed and plug
connections.
Installation is thereby complete.
2. When everything is in order, amiliarize yoursel with the machine at a
low resistance
Setting and make your individual adjustments.
Note:
Please keep the tool set and the instructions in a sae place as these
may be required or repairs or spare parts orders becoming necessary
later.
20