Installation
④
There are 4 brackets and fasteners used with the heater. Furthermore, in the
canal of back side of the heater there are 4 square fastener washers 25×25mm.
Relieve square washers (Figure 7.1) and fasten 2 brackets to the
canal of the backside of the heater by the help of screws (Figure 7.2.)
⑤
Fasten the brackets at the appropriate distance of each other(45-55cm)
(Figure 8).
⑥
Two other brackets are fastened by the help of fasteners at the appropriate
distance on the wall parallel to the floor(At least 1.8 m from the floor and at
least 0.5 m from the ceiling).(Figure 5).
Hergestellt für Dilaw Warehouse GmbH // Fuggerstraße 15a // 48165 Münster // Germany
14
www.eshopping.de