LGB Mikado Bedienungsanleitung Seite 11

button the matching number of
times. For example, to trigger the
bell, press button "2" on the Loco
Remote or Universal Remote. If
you are using a Train Mouse,
press the function button twice to
trigger the bell.
1: Whistle (1 long blast)
2: Bell
3: Smoke generator off/on
4: Sound off/on
5: Firebox off/on
6: Brake sound
7: Announcement: "The train is
about to leave. All Aboard!"
8: Whistle signal
(2 long, 1 short, 1 long blast)
Hint: If this model is equipped
with a decoder, the digital/analog
DIP switches on the loco circuit
board must be set to OFF. The
DIP switches should remain in
this setting, even if the model is
used on an analog layout.
Attention! After extended opera-
tion, this model may leave carbon
dust or other debris around the
track. This dust and debris can
stain carpet and other materials.
Consider this when setting up
your layout. Ernst Paul Lehmann
Patentwerk and LGB of America
are not liable for any damages.
SERVICE
Do-It-Yourself Service Levels
Level - Beginner
Level - Intermediate
Level - Advanced
Attention! Improper service will
void your warranty. For quality
service, contact your authorized
retailer or an LGB factory service
station (see Authorized Service).
Hint: Additional expert instruc-
tions for many LGB products are
available at www.lgb.com.
Lubrication
The axle bearings and the side
rod ends should be lubricated
occasionally with a small amount
of LGB Maintenance Oil (50019).
Cleaning
This model can be cleaned exter-
nally using a mild detergent and
"Crossing"
gentle stream of water. Do not
immerse this model.
Attention! This model is equip-
ped with sound electronics. Do
not expose the speaker directly to
water.
Replacing the light bulbs
Front light: Pull the number plate
off the lantern (Fig. 6). Remove
the screw holding the lantern (Fig.
6a). Pull the lantern housing away
from the model. Remove and
replace the bulb. Reassemble.
Rear light: Pull the lantern
housing away from the model.
Remove and replace the bulb.
Reassemble.
Cab light: Using tweezers, remo-
ve and replace the bulb.
Replacing the
smoke generator
- Pull the smokebox front from the
model (Fig. 4).
- Pull the safety cover out of the
smoke stack (Fig. 7).
- Turn the smoke stack clockwise
and remove it (Fig. 7c).
- Remove three Philips screws
inside the smoke box (Fig.
7a/7b).
- Carefully pull out the circuit
board about an inch (Fig. 8).
- Remove the wires for the smoke
generator from the circuit board.
- Use pliers or tweezers to pull the
old smoke generator out of the
stack (Fig. 8a).
- Push the replacement generator
into the stack.
- Plug the wires for the smoke
generator onto their respective
pins on the circuit board.
- Reassemble.
Replacing the traction tire
- Remove the hex head screw on
the wheel with the traction tire.
- Remove the side rods from the
wheel with the traction tire.
- Use a small, straight-blade
screwdriver to replace the trac-
tion tire:
- Pry the old traction tire out of the
wheel groove.
- Gently insert the new traction
tire into the wheel groove.
- Make sure that the traction tire is
seated properly in the wheel
groove.
11