Nibe ESV 20 Bedienungsanleitung Seite 12

GB
10
GB
General
This accessory is used when FIGHTER 360P / 1120 /
1220 or VVM 240 is installed in homes with two differ-
ent heating systems that require different flow temper-
atures, for example, when the home has both a radia-
tor system and floor heating system. In the text below
heating system 1 refers to the system that requires the
highest temperature and which is connected to the
ordinary flow and return connections.
Heating system 2 refers to the heating system that
works at the lowest temperature.
The combined water flow in the two heating systems
should not exceed 1700 l/h.
The number designations in brackets in the following
text refer to the "Component placement" section and
the "Installation and Maintenance Instructions" for the
FIGHTER 360P / 1120 / 1220 or VVM240 in question.
Contents
1 Pipe with straight coupling
1 Circulation pump with cable
2 Shut off valves
1 Shunt valve with motor
1 5-core cable
1 Relay card with cabling
2 Temperature sensor
1 Cabling, edge board contact
4 Round pin adapter
1 Connection box
1 Insulation tape
ESV 20