Aventura 126026 Bedienungsanleitung Seite 28

GB
the horizontal line as markings onto the fixing sub-
strate. Now position one bracket each onto these
markings as a template and transfer the position
of the fastening holes onto the wall.
– Drill at the marked positions; in doing so, drill
slightly deeper than the fixture length (► P. 3,
item 3).
– Insert fixture into the drilled holes (► P. 3, item 4).
– Align the consoles horizontally and vertically and
screw into position using the fixtures.
– wall installation: ► P. 4, item 5
– ceiling installation: ► P. 4, item 6
• Installation sequence: Bracket, washers, locking
ring, nuts.
NOTICE! Danger of product damage!
Shorten protruding fastening screws or
threaded rods, such there is no risk of dam-
age to any awning components or awning
cloth.
– Insert the awning into the brackets (two people
are needed) (► P. 4, item 7). For this, insert the
awning's supporting tube into the brackets, place
the nut on from the top, screw in the bolt and
washer from underneath, and tighten (► P. 4,
item 8).
NOTICE! Danger of product damage!
Maximum screw tightening torque 27 Nm.
The smallest distance between the bracket
and the arm holder should be 1 cm.
DANGER! Risk of injury! Before using for
the first time, make absolutely sure that all
screws and other fastening elements are
firmly seated.
Measuring the angle of inclination
► P. 4, item 9
– Use the adhesive strips to simply affix the gauge
for angle of tilt (2) to the spirit level (1).
– Hold the gauge for angle of tilt (2) and spirit
level (1) laterally against the awning fabric and
read the angle of tilt from the scale.
Setting the angle of the awning
► P. 5, item 10
Note: Extend the awning by 0.5 metres.
Depending on requirements you can set the cloth
inclination between 0° and 45°. Please note that a
minimum cloth inclination of 14° is required to the
rainwater drain. You must perform the following work
steps to adjust the cloth inclination:
– Loosen the fastening screws (3) on the left arm
holder by 1-2 turns. Caution, do not remove!
– Loosen the locking screw (4) to such an extent
that the left folding arm can be adjusted to its
desired inclination.
– Lift (relieve) the left folding arm by hand and lift or
lower the drop rod (front profile) to the desired
angle of inclination by turning the setting
screw (5) in clockwise or counter-clockwise direc-
tion.
28
– Once the desired inclination has been reached,
tighten the locking screw and the fastening
screws again.
– Perform the same work steps on the right arm
holder.
NOTICE! Possible damage to the awning
fabric! The fabric tilt must be adjusted uni-
formly on both the sides. If the front rail is not
horizontal, the awning cloth will roll unevenly
and it may lead to damages.
– Use a spirit level to check that the front cross bar
is horizontal.
– Adjust as necessary on one side until the front
cross bar is horizontal.
• Angle of inclination: ► Technical data – p. 30
Aligning the hinged arms
► P. 5, item 12
– Extend the awning halfway.
– Check the alignment of the hinged arms: the
hinged joints should be on a level.
– The fall pipe for the hinged arms should be
adjusted until the hinged joints of the hinged arms
are on a level.
– Test the awning by extending and retracting it
fully.
– Adjust the fall pipe until the hinged arms close
parallel to the pipe and the fabric spindle.
Operation
DANGER! Risk of injury! Check all screws
once a year for firm seating.
Crank mechanism of the awning
► P. 5, item 12
Please always observe:
The crank mechanism of the awning has no end stop
for the limitation of the cloth shaft turns. Therefore,
please always ensure that the awning cloth is wound
onto the cloth shaft at the top to avoid damage to the
cloth.
– If the winding direction is wrong, please com-
pletely unwind the cloth. It is then totally slack and
is now wound on around the top in case of further
winding in the same direction.
• The cloth must be tightly wound!
– When turning the crank handle, please hold it ver-
tically to avoid excess wear to the crank and eye-
let of the gear mechanism.
Care, storage, disposal
Cleaning and care
NOTICE! Possible damage to the awning
fabric! Do not unnecessarily expose the
awning to wet conditions!