Memory Card - Spypoint TINY Bedienungsanleitung

40
To insert the battery case inside the camera
Connector
SPY SPY

MEMORY CARD

Using a memory card (sold separately, refer to the section
"OPTIONS") is required to operate the camera SPYPOINT
TINY. When the camera is turned on, the screen displays
"Insert memory card" in "Photo" or "Video" mode if no
memory card is used, the camera also beeps. The SD slot of
the camera has a 32 GB memory capacity. Before inserting
or removing the memory card, the camera must be turned
off. Failing to do so may cause loss of or damage the pictures
already recorded from the memory card. When the SD card is
full, the viewing screen indicates "Disk full" when "Photo",
"Video" or "Test" mode are selected. The following data shows
an approximate quantity of photos or video length that can be
taken by the camera depending on the memory card capacity.
TINY
Connector
P P INT INT
TM
RESOLUTION 2.0 GB
5 MP 1190
6 MP 952
8 MP 635
10 MP 595
12 MP 476
VIDEO RESOLUTION
320 x 240 45 min
640 x 480 30 min
If the memory card is locked in, the screen will indicate "Card
protect" when "Photo", "Video" or "Test" mode are selected.
PROGRAMMING
Turn on the camera to navigate in the interface by pressing
"" or "" and press "OK" for selection. To modify the
selection, press "" and "" again and press "OK" to
confirm. To return to the previous menu press "".
PHOTO
To take pictures. The "Photo" mode must be selected by
pressing "OK"; the test light in the front of the camera will
wink for 60 seconds to allow the operator to walk away from
the camera.
VIDEO
To take videos. The "Video" mode must be selected by
pressing "OK"; the test light in the front of the camera will
wink for 60 seconds to allow the operator to walk away from
the camera.
4.0 GB 8.0 GB 32 GB
2380 4760 19040
1904 3808 15232
1270 2540 10160
1190 2380 9520
952 1904 7616
1h30 3h 12h
1h 2h 8h
41