Get Started - RUSTA 906512060401 Gebrauchsanweisung

GET STARTED!

• The appliance requires no installation; it should be used solely as a portable appliance.
Mains operated portable appliances are not suitable for use in a bathroom.
• During the first few minutes of initial use, you may notice a slight odour and some
smoke. This is normal and will quickly disappear. It is the coating applied to the
heating elements to prevent rusting during transit.
• Before plugging the unit into the mains, ensure by visual inspection that the unit is
intact and has not suffered any damage during transit.
CAUTION!
The appliance must be always placed on a flat and
stable surface.
OVERHEATING AND TIP-OVER SWITCH
For your safety this appliance is fitted with a tip-over switch. When the product is moved
you will hear the tip over switch moving inside the product. Please note that this is fully
normal. When you use the appliance in an upright position on a flat and stable surface,
the tip-over switch will be on.
In the event the tower heater is knocked over, the tower heater will stop functioning
automatically. To reset, disconnect the plug from the power for a few minutes, remove
the cause of overheating then plug the appliance in again.
USE
Turn the thermostat knob (right) in a clockwise direction until it reaches
the maximum setting.
• Heating at reduced power: Turn the switch knob to setting I (1250 W).
• Heating at full power: Turn the switch knob to setting II (2000 W).
• Heating at reduced power with oscillation: Turn the switch knob to setting I +
(1250 W).
• Heating at full power with oscillation: Turn the switch knob to setting I I +
(2000 W).
• Switching off: Turn the switch knob to setting .
7