ALGE-Timing Timy Bedienungsanleitung Seite 9

TER FF ER <cr>
TER 02 ER <cr>
TER FF EI 3
TER 03 EI 3
TER FF EC 3
TER 03 EC 3
TER FF ES 1
TER 03 ES 2
TER FF F
TER FF F "OEM6_8<cr>"
TER FF F
"TIMES13<cr>"
TER FF F "TI8_10<cr>"
TER FF F "OEM8_16<cr>"
TER FF FLUGSCHANZE557<cr>
TERLIST<cr>
With this command the pc starts the Timy to build up the data chain.
Also a list will be sent ti the pc.
It can look like:
TERMINAL[00]=01=1=00000005f74e
TERMINAL[01]=02=1=00000008e978
TERMINAL[02]=03=1=00000009e300
TERMINAL[03]=04=1=00000009963f
TERMINAL[04]=05=1=00000005f968
TERMINAL[05]=06=1=00000008ef81
TERMINAL[06]=07=1=00000008eefe
TERMINAL[07]=08=1=00000005eb89
TERMINAL[internal number]=NUMBER=present=Hardware-ID
internal number
NUMBER
present
Hardware-ID
TER WRITE-NUM:<2-digit NUMBER><cr>
TER FF B <cr>
Timy Terminal
<cr>
<cr>
<cr>
<cr>
" 111 22 22 22<cr>"
" 111 22 22 22<cr>"
choose the FONT
6
small letters allowed
max 8 lines possible
8
small letters allowed
max 4 lines possible
8
No small letters
max 6 lines possible
8
small letters allowed
max 4 lines possible
a special input mask will be defined like this:
Fl
0,0
BIB
The internal number is without interest for the user.
This number can be entered in the menu on the Timy.
1 = present, 0 = absent
12-digits also visible in the info-menu
RESET alle Blöcke und Texte löschen
INIT Blocks to 0. BLANK and 0 means all blocks
Blocks to 0. 1 to 5 means block 1 to 5
CLEAR blocks to BLANK, the rest is like INIT
blocks to BLANK, the rest is like INIT
SET Line 1 or 2
Pixel width 8 Pixel height
All characters not same width
Pixel width 13 Pixel height
All characters not same width
Pixel width 10 Pixel height
All characters not same width
Pixel width 16 Pixel height
La Ou
Fl=Flight, La=Landing,Ou=Out
0,0 0,0 max.
20,0
Send=OK BIB 3 digits
after the komma only 0 or 5 allowed
TERMINAL[00] is always the MASTER.
each line is terminated with <cr>
You can configure a Timy as a SLAVE
and give it a NUMBER.
Beep for 0,1 s
Seite 9
All characters same width
5,0 5,0 7,0
20,0 max points
possible