AEG LP7450 Benutzerinformation Seite 9

The end of the drain hose
must always be ventilated ,
i.e. the inner diameter of the
drain pipe (min. 38 mm -
min. 1.5") must be larger
than the external diameter
of the drain hose.
5.Without the plastic hose guide, to a
sink spigot- Put the drain hose in the
spigot and tighten it with a clamp. Refer
to the illustration.
4. ACCESSORIES
4.1 Fixing plate kit
(4055171146)
Available from your authorised dealer.
If you install the appliance on a plinth,
secure the appliance in the fixing plates.
Read carefully the instructions supplied
with the accessory.
4.2 Stacking kit
Make sure that the drain hose makes a
loop to prevent particles going into the
appliance from the sink.
6. Position the hose directly to a built-in
drain pipe in the room wall and tighten it
with a clamp.
The tumble dryer can be stacked on the
top of the washing machine only by
using the correct stacking kit
manufactured and approved by AEG.
Verify the compatible
stacking kit by checking the
depth of your appliances.
The stacking kit can be used only with
the appliances specified in the leaflet
provided with the accessory.
Read carefully the instructions supplied
with the appliance and with the
accessory.
WARNING!
Do not put the tumble dryer
under the washing machine.
ENGLISH 9