AEG LP7450 Benutzerinformation Seite 7

6. . Remove the power supply cable
and the drain hose from the hose
holders.
It is possible to see
water flowing from the
drain hose. This is
because the washing
machine has been tested
at the factory.
7. Remove the three transit bolts and
pull out the plastic spacers.
8. Put the plastic caps, that you find in
the user manual bag, in the holes.
1
2
3.2 Information for installation
Positioning and levelling
Adjust the appliance correctly to prevent
vibration, noise and movement of the
appliance when it operates.
1. Install the appliance on a flat hard
floor. The appliance must be levelled
and stable. Make sure that the appliance
does not touch the wall or other units
and there is air circulation below the
appliance.
2. Loosen or tighten the feet to adjust
the level. All feet must rest firmly on the
floor.
The inlet hose
We recommend that you
keep the packaging and the
transit bolts for any transport
of the appliance.
WARNING!
Do not put cardboard, wood
or equivalent materials
below the appliance feet to
adjust the level.
CAUTION!
Make sure there is no
damage to hoses and there
are no leaks from the
couplings. Do not use an
extension hose if the inlet
hose is too short. Contact
the service centre for a
replacement inlet hose.
ENGLISH 7