Stahl ConSig 8040 Serie Betriebsanleitung Seite 33

Dimensional drawings (All dimensions in mm [inches]) – Subject to modifications
04584E00
Additional dimensions for 8161 cable glands
04585E00
Additional dimension for flanges
7.2 Mounting / dismounting, operating position
This device is suitable for outdoor and indoor use.
• Provide a protective roof or wall if the enclosure and explosion-protected electrical
equipment are used outdoors.
7.3 Installation
Operation under difficult conditions, such as, in particular, on ships, requires
additional measures to be taken for correct installation, depending on the
place of use. Further information and instructions on this can be obtained
from your regional sales contact on request.
7.3.1 Mount cable entries
The following cable entries can be used to insert cables and conductors:
• Plastic or metal cable entries for permanently installed electric lines or
• Plastic or metal cable entries with strain relief for electric lines, which are not
permanently installed.
Options for sealing unused entry holes:
• use plastic or metal stopping plugs with a corresponding certificate.
Explosion hazard due to unsuitable cable entries at a low ambient
temperature!
Non-compliance results in severe or fatal injuries.
• At low ambient temperatures (< -20 °C), use cable entries (material,
130937 / 8040606300
2018-01-30·BA00·III·en·05
Dimension a
min.
M20 25
[0.98]
M25 27
[1.06]
Flanges Dimension b
brass 16 [0.63]
moulded 16 [0.63]
material
insulation) specially designed for these temperatures or provide cable
entries and actuators with special protection
(e.g. using a mechanical safety device).
Mounting and installation
max.
31
[1.22]
33
[1.30]
DANGER
Control and monitoring devices
ConSig 8040 series
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
13