Stahl ConSig 8040 Serie Betriebsanleitung Seite 25

3 Safety notes
3.1 Operating instructions storage
• Read the operating instructions carefully.
• Store the operating instructions at the mounting location of the device.
• Observe applicable documents and operating instructions of the devices
to be connected.
3.2 Personnel qualification
Qualified specialist personnel are required to perform the tasks described in these
operating instructions. This primarily applies to work in the following areas
• Project engineering
• Mounting/dismounting the device
• (Electrical) Installation
• Commissioning
• Maintenance, repair, cleaning
Specialists who perform these tasks must have a level of knowledge that meets
applicable national standards and regulations.
Additional knowledge is required for tasks in hazardous areas! R. STAHL recommends
having a level of knowledge equal to that described in the following standards:
• IEC/EN 60079-14 (Electrical installations design, selection and construction)
• IEC/EN 60079-17 (Inspection and maintenance of electrical installations)
• IEC/EN 60079-19 (Equipment repair, overhaul and reclamation)
3.3 Safe use
Before installation
• Read and observe the safety notes in these operating instructions!
• Ensure that the contents of these operating instructions are fully understood by the
personnel in charge.
• Consult with R. STAHL Schaltgeräte GmbH if using the device under operating
conditions which are not covered by the technical data.
For assembly and installation
• Observe national assembly and installation regulations (e.g. IEC/EN 60079-14).
• Observe national safety and accident prevention regulations.
• During installation and operation, observe the information
(characteristic values and rated operating conditions) on the type plates and data
plates and information signs located on the device.
• Before installation, make sure that the device is not damaged.
• Only use installation components (e.g. cable entries) that have a corresponding
certificate.
• Observe the installation conditions of potential installation components
(See the "Technical data" section).
• Ensure that cable entries from manufacturers other than R. STAHL have a correct and
sufficient degree of protection.
• Do not subject cable entries and stopping plugs to any tensile stress and tighten them
with the right torque (for information on torque, see the operating instructions for the
cable gland).
130937 / 8040606300
2018-01-30·BA00·III·en·05
Control and monitoring devices
ConSig 8040 series
Safety notes
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
5