Stahl ConSig 8040 Serie Betriebsanleitung Seite 26

Function and device design
EN
EN
Maintenance, repair, commissioning
EN
• Before commissioning, make sure that the device is not damaged.
• Work on the device, such as installation, maintenance, overhaul, repair, may only be
EN
carried out by appropriately authorised and trained personnel (see Section 3.2).
EN
• Perform only maintenance work or repairs described in these operating instructions.
EN
3.4 Modifications and alterations
EN
EN
EN
EN
EN
EN
EN
EN
EN
4 Function and device design
EN
EN
EN
EN
EN
EN
EN
EN
4.1 Function
EN
Application range
EN
The control devices of Series 8040 are explosion-protected equipment for stationary
mounting, certified for use in hazardous areas of Zones 1, 2 and 21, 22. They are used
for control and switching functions in areas subject to explosion hazards.
6
Control and monitoring devices
ConSig 8040 series
Explosion hazard due to modifications and alterations to the device!
Non-compliance results in severe or fatal injuries.
• Do not modify or alter the device.
No liability or warranty for damage resulting from modifications and
alterations.
Explosion hazard due to improper use!
Non-compliance results in severe or fatal injuries.
• Use the device only in accordance with the operating conditions
described in these operating instructions.
• Use the device only for the intended purpose specified in these
operating instructions.
DANGER
DANGER
130937 / 8040606300
2018-01-30·BA00·III·en·05