Zipper Maschinen ZI-RD300 Betriebsanleitung Seite 31

A Wheels:
Mount the wheels and fasten them with nuts.
B Handle frame:
Mount the handle frame assembly to the chasis
and secure it with M10X25 bolts, washers and
nuts at the front and M10X45 bolts, washers and
nuts at the rear.
C Dump box:
Install the dump box and fasten the front with
two Ø4 R-clips.
13 OPERATION
Device to be operated in a perfect state only. Inspect the device visually every time it is to be
used. Check in particular the safety equipment, controls and screwed connection for damage
and if tightened properly. Replace any damaged parts before operating the device.
13.1 Operation instructions
•
•
•
•
•
•
•
•
•
•
13.2 Functions of components
1 Engine switch: The engine switch must be in the ON position for the engine to run.
Turning the engine switch to the OFF position stops the engine.
2 Throttle control: Controls engine speed. Put the throttle control on low speed(L)or high speed(H)
3 Right steering lever: Operate the lever to turn right
4 Clutch control lever: Squeeze the lever, clutch engaged. Release the lever, clutch disengaged
5 Left steering lever: Operate the lever to turn left
7 Gear selection lever: Controls forward (3x) or reverse (1x) movements of the machine.
8 Tipping handle: Controls the tipping of the dump box (manual!)
ZIPPER MASCHINEN GmbH
ZI-RD300
Disengage clutch lever before starting the engine
Always hold the unit with both hands when operating.
Do not rapidly accelerate, turn sharply or stop.
Do not overload the machine capacity
Always make certain that the weight is evenly balanced
Always move in directions parallel with the slope (up or down).
Change the gears only when the machine stands still!
To avoid danger, do not shift gears on slopes
Attention: While tipping the centre of gravity will change suddenly!
Do not tipping on soft ground
www.Zipper-Maschinen.at
NOTICE
OPERATION
31