Zipper Maschinen ZI-RD300 Betriebsanleitung Seite 30

• Vibration:
The declared vibration emission value has been for a standardized test is measured and can be used
to compare one tool with another electric are.
The declared vibration emission value may also be used for a preliminary assessment of exposure.
Warning:
Emission level of vibration can be different from the specified value during the actual use of the
electric tool, depending on the manner in which the power tool is used. When you feel
uncomfortable or notice discoloration of skin on your hands during the use of the machine, stop
working immediately. Observe sufficient break times to rest. Failure to have sufficient break times
may result in a hand-arm vibration syndrome.
The extent of exposure depending on the type of work or machine use should be estimated and
appropriate breaks taken. In this way, the extent of exposure can be considerably reduced over the
entire work time. Minimize the risk caused by vibrations. Maintain this machine according to the
instructions in the manual.
These risk factors can be minimized through obeying all security and operation instructions,
proper machine maintenance, proficient and appropriate operation by persons with technical
knowledge and experience.
In spite of all safety is and remains her healthy common sense and their corresponding technical
qualification / training for use of the machines most important safety factor!!
12 ASSEMBLY
Please check the product contents immediately after receipt for any eventual transport damage or
missing parts. Claims from transport damage or missing parts must be placed immediately after
initial machine receipt and unpacking before putting the machine into operation. Please
understand that later claims cannot be accepted anymore.
12.1 Assembly
ZIPPER MASCHINEN GmbH
ZI-RD300
www.Zipper-Maschinen.at
ASSEMBLY
30