Retrofit Image Input And Output Signals; Input Signals - Fronius Ri Fb Inside/I Bedienungsanleitung

Retrofit Image Input and Output Signals

Input Signals

The signals listed below are available from firmware V1.6.0 for all Inside/i sys-
tems.
Only in Job mode (E17 - E32):
48
Serial no. Signal designation
E01 Welding on
E02 Robot ready
E03 Operating mode bit 0
E04 Operating mode bit 1
E05 Operating mode bit 2
E06 —
E07 —
E08 —
E09 Gas test
E10 Wire forward
E11 Wire backward
E12 Error quit
E13 Position search
E14 Purge welding torch
E15 —
E16 —
E17 - E24 Job number
E25 - E31 Program number
E32 Welding simulation
E17 - E31 Job number
E32 Welding simulation
E33 - E40 Output set value - Low byte
E41 - E48 Output set value - High byte
Arc length correction, set value
E49 - E56
Low byte
Arc length correction, set value
E57–E64
High byte
E65 - E72 Pulse or dynamic correction
E73–E80 —
E81 - E88 —
E89 - E96 —
Range Action
High
High
See table Value High
range for opera-
High
ting modes on
page 49 High
High
High
High
High
High
High
0 to 99
1 to 127
High
0 to 999
High
0 to 65535
(0 to 100%)
0 to 65535
(-30 to +30%)
0 to 255
(-5 to +5%)