Salda STOUCH Bedienungsanleitung Seite 6

5. RS485 A (Modbus)
6. GND
7. 0-10 VDC input (used for pressure or CO
source.
8. 0-10 VDC output (used for control of 0..10 VDC fans).
1. NOTICE: when the remote controllers are used with air-quality converter (the power
supply and analog output GND of witch are not electrically separate), then constant volt-
age (DC) has to be used for their power supply.
2. NOTICE: The power source must be selected according to the used currents of the
remote controller and air quality converter. Power source is not supplied with the remote
controller.
5. RECOMMENDATIONS FOR CONNECTION OF THE REMOTE CON-
TROLLER TO OTHER DEVICES
5.1. WHEN CONTROL PANEL IS USED WITH AIR HANDLING UNIT WITH
INTEGRATED AUTOMATICS
F - Fuse
G - constant voltage
(DC) power supply
M1 - EKO fans
6 | EN
sensor). The sensor is powered from a separate power
2
N L
Duct CO2 transsmiter S-KCO2 (DSC-G)
-F
-G
230VAC_24VDC
-F
-STouch
IP54
-A2
RS485_2
CON1
AHU
STOUCH v2019.1