Salda STOUCH Bedienungsanleitung Seite 10

• Maximum ventilation. The unit operates in maximum speed (according to boost configuration).
Maximum speed is limited by timer which can be easily set (see table);
• Maximum speed can be activated using fast button. When preset maximum fan speed (boost)
time is over, previous speed is automatically restored;
• 0..10 VCC CO sensor can be connected for activation of maximum speed based on the given
2
CO parameters.
2
9. TEMPERATURE
• Temperature from 15 to 30 C may be set by remote controller. Note: Temperature of MCB control-
ler can be adjusted from 0 up to 40C (it depends on MCB settings).
• Supply air and set temperatures can be displayed interchangeably (set temperature is displayed
for 5 seconds, then supply air temperature is displayed for 2 seconds)
10. REMOTE CONTROL (MODBUS)
Controller supports fully configurable Modbus interface. Panel can operate as master and slave
device in modbus network and also it can be fully controlled and configured not only via service
menu but also via modbus interface.
11. USER MENU
In order to reach user menu, press down B2 and B3 for 3 seconds.
In user menu, menu items (P.01, P.02 etc.) settings are displayed sequentially. Menu item is select-
ed using elements B4 and B6. After pressing B5, value of selected parameter is shown and can be
changed using elements B4 and B6. Press B5 to save the parameter and to return to menu.
Due to limitations of segment display, values of P.04 and P.05 are shown divided by 10, i.e. if 20 is
displayed, it means that real value is 20 x 10 = 200.
P.06 - Filter timer resets by pressing B2 and B3 for more than 5 seconds. Filter timer also resets
by clearing fault signal.
Touch element B1 to exit menu.
NO. NAME
P.01 Sleep mode
P.02 Sound
P.03 Supply air temperature display
P.04 CO required (ppm)
2
P.05 CO allowed difference
2
P.06 Filtrer timer
10 | EN
POSSIBLE VALUES
0 - Off
1 - 99 sleeping time in seconds
0: Off
1: 1 – 9 sound tone
0: Not shown
1: Shown interchangeably with the set
temp
0 – 99 x 10 ppm
0 – 99 x 10 ppm
PRV control board: indicates days
passed after the last filter change.
MCB control board: indicates days left
to the next filter change.
D E FA U LT
VALUE
0
2
0
20 x 10
5 x 10
0
STOUCH v2019.1