Salda STOUCH Bedienungsanleitung Seite 15

F.30 Alarm 3 address
F.31 Alarm 4 address
F.32 Alarm 5 address
F.33 Alarm 6 address
F.34 Alarm 7 address
F.35 Alarm 8 address
F.36 Alarm 9 address
F.3 Alarm 10 address
F.38 Restore controller factory settings
Modbus (Holding register) type param-
F.39
eter reading and changing tool
Modbus (Coil register) type parameter
F.40
reading and changing tool
F.41 Control panel version
Fan's controlled by 0..10 VDC signal
F.42
start delay time in seconds
F.43 0..10 VDC Disable / Enable
Restore factory settings of PRV control
board.
F.44
Note: accessible only by connecting to
PRV controller
F.45 Tool for air flow adjustment.
To restore factory settings, service password "022" should be reentered.
Due to limited number of symbols in segment display, modbus addresses of "CUSTOM" device are
entered as HIGH and LOW bytes in hexadecimal (HEX) system. Using buttons B2 and B3, select
HIGH or LOW bytes, "H.00" and "L.00" are displayed respectively.
14. MODBUS REGISTER READ AND RECORD TOOL
Modbus register read and record tool indicated in F.39 and F.40 items is useful when you want to
set the unit's parameters, which by default are not controlled by remote controller, but these param-
eters are accessible via Modbus. F.39 is used for Holding type registers and F.40 used Coil registers.
Using the Tool:
1. Modbus register address is indicated and confirmed by "MAX" button.
2. The tool reads the address value and shows on a segmental display (the value flashes).
3. Change the value with "+" and "-" button and confirm with the MAX button.
4. The tool records the value to indicated register and return to the service menu.
STOUCH v2019.1
00:00 - FF:FF
00:00 - FF:FF
00:00 - FF:FF
00:00 - FF:FF
00:00 - FF:FF
00:00 - FF:FF
00:00 - FF:FF
00:00 - FF:FF
0: No
1: Yes
0 - 999
0 - 999
-
0 - 120
0: OFF
1: ON
0: No 1: Yes
0 - 100
00:00
00:00
00:00
00:00
00:00
00:00
00:00
00:00
0
0
0
-
0
0
0
0
EN | 15