CCV Pad Next Erste Schritte Seite 18

Procedure
1. Connect the terminal to the power source via
the power adapter.
2. The device starts up.
3. Start the commissioning with „YES".
4. Select the desired terminal language.
5. Enter and repeat the 8-digit terminal ID provi-
ded by your network operator.
6. Optional: Select the desired PU. The PU corre-
sponds to a communication dial-up set called
by your network operator along with the ter-
minal ID. If only one dialing set was stored,
there is no query of the PU.
7. Select one or more communication types
(LAN, Wifi, 3G / 4G). If you are commissio-
ning several types of communication, you can
switch between them by softkey (eg Wifi - 3G).
8. If you want to operate the terminal with a cash
register, the cash register protocols ZVT and
O.P.I. via TCP / IP are always active and do not
need to be activated. Only in the case of ZVT
via a serial RS232 connection, the cash regis-
ter interface must be activated accordingly.
9. After setting the communication, the terminal
automatically connects to your payment net-
work operator and performs initialization, ad-
vanced diagnostics, and EMV diagnostics.
10. After successfully establishing the connection
and carrying out the initialization, extended
diagnostics and EMV diagnostics, the terminal
will print corresponding documents. Please
check this for a successful implementation.
Afterwards the terminal is ready for use.
1. Connect
2. Turn on
3. Start startup
4. Select your
language
5. Enter
Teminal-ID
6. Select PU
7. Setup
Communication
8. Optional: setup
cash register
9. Host selection
10. Ready