WOLFF BS 125 Originalbetriebsanleitung Seite 17

11. Accessoires
Use only genuine accessories.
Use only accessories which fulfi l the requirements
and specifi cations listed in these operating
instructions.
Bar side handle
For a complete range of accessories, see
www.wolff -tools.com or the catalogue.
12. Repairs
Repairs to electrical tools must be carried out
by qualifi ed electricians ONLY!
If the connection lead is damaged, it must be
replaced by a special connection lead. Contact your local
WOLFF representative if you have WOLFF power tools re-
quiring repairs. You can download a list of spare parts from
www.wolff -tools.com.
12.1 Spare parts
Spare parts can be found on the internet at:
http://webcatalog.wolff -tools.com
Always have your guard repaired by qualifi ed personnel
only using genuine spare parts. This will ensure that the
safety of the guard is maintained.
Attention!
The BS 125 fl oor grinder cannot be used for „all"
fl oor work. The design of the machine is not
suitable for large areas that must be worked in
continuous operation, for this we off er the fl oor
grinder BS 180 or a Neo 230.
Failure to observe the design of the machine will
void the warranty on the fuse coupling, the fi eld and
the anchor of the machine.
13. Environmental Protection
The generated grinding dust may contain harm
ful substances. Dispose appropriately.
Observe national regulations on
environmentally
compatible disposal and on the recycling of
disused machines, packaging and accessories.
Only for EU countries: Never dispose of power tools in
your household waste! In accordance with European
Directive 2002/96/EC
Relating to electrical and electronic waste and
implementation of national law, used electrical tools
must be collected separately and disposed of in an
environmentally friendly manner at recycling centres.
14. Technical Specifi cations
Changes due to technological progress reserved.
Ø = max. diameter of the accessory ......... 125 mm
max,1 = max. permitted thickness of the
t
clamping shank on accessory when
using 2-hole nut (13) ............................ 10,0 mm
max,2 = max. permitted thickness of clamping
t
shank on accessory when using-
„Quick" clamping nut (1) ........................ 6,8 mm
max,3 = roughing disc/cutting disc::
t
max. permitted thickness of accessory... 6,8 mm
M = Spindle thread ........................................ M 14
l = length of the grinding spindle ............... 20 mm
n* = no-load speed (maximum speed) ..... 11.000 U
P1 = rated input power ................................ 1550W
P2 = power output ......................................... 940W
m = Weight without main cable..................... 2,5 kg
14.1 Come with
Concrete grinding BS 125....................................#80582
with safety cover
Diamond grinding disc.........................................#72983
Hearing protection............................................. #15315
Bar side handle................................................. #80480
Safety gloves................................................... #15316
Carrying case................................................... #74844
Twin hole spanner............................................. #14960
Manual............................................................#80720
Measured values determined in conformity with EN
60745.
Machine in protection class II
~ AC Power
* Machines with the designation BS 125:
Energy-rich, high-frequency interference can cause
fl uctuations in speed. The fl uctuations disappear,however,
as soon as the interference fades away.The technical spe-
cifi cations quoted are subject to tolerances (in compliance
with the relevant valid standards).
Emission values
These values make it possible to assess the
emissions from the power tool and to compare
diff erent power tools. Depending on the operating
conditions, the condition of the power tool or the
accessories, the actual load may be higher or lower.
For assessment purposes, please allow for breaks
and periods when the load is lower. Based on the
adjusted estimates, arrange protective measures
for the user e.g. organisational measures.
EN
17