Vexve AM20-W Benutzeranleitung Seite 45

Quick setup guide
1. Set the valve and actuator to the zero posi-
tion and check the direction of the valve rota-
tion (the default setting is right-handed, which
opens clockwise).
2. Install the adapter on the valve stem and, if
necessary, put the pin in place. Fasten the
actuator in place by using the provided long
screw. Set switch D of the motor unit to
manual operation (hand symbol) and check
that the combination works properly and
easily. Set the motor unit switch to automatic
operation (A).
3. Connect the supply water sensor to the sup-
ply water pipe and the motor unit. Connect
the RF transmitter to the motor unit and posi-
tion the transmitter as high as possible.
4. Remove the plastic protecting the room unit
batteries and check that "RU" appears on the
display.
5. Power on the motor unit.
6. Push the right-hand button on the room unit.
The text "PAIR" appears on the display.
7. After a while, "PAIR ok" appears on the
display. This means that the room unit is suc-
cessfully connected to the RF transmitter. If
this does not happen, see page 41.
8. Push the right-hand button to select the heat-
ing method: HI - radiator heating/LO - floor
heating/CT - constant temperature control.
Use the right-hand button to modify options
and confirm changes. Use the rotating knob
to choose functions and navigate the menu.
www.vexve.com
9. Under "Valve", choose the direction of the
valve rotation. The default setting is right-
handed.
10. "RF" displays the calculated average radio
signal strength. Use this information if you
suspect that there is a problem with indoor
data communications.
11. Under "DEFA", you can reset the device using
factory settings. The device has to be paired
after a reset » continue from step 5.
12. Leave the setup menu by pushing the ECO
button on the left-hand side.
13. If you pushed the ECO button at an earlier
stage, use a ballpoint pen to push the but-
ton on the back panel to return to the setup
menu.
14. Place the room unit indoors in a central
location where there is no draught, set the
desired temperature, have a cup of coffee,
and relax...
15. For the user menu options, please refer to
"Enter button (C)" on page 44.
EN
45