Vexve AM20-W Benutzeranleitung Seite 36

Room unit controls
Figure 1, page 2
A - Rotating knob
· For changing the temperature and navigating
the menu functions.
B - ECO button
· Single push on the default screen:
ECO mode on/off
(the factory setting is 8 hours/20.5°C).
· Single push in a menu:
returns to the default screen.
· Push and hold (for more than 3 seconds) on the
default screen: HOLIDAY mode on
(the factory setting is 30 days/18.5°C).
· If a room unit is unpaired, a push of the ECO
button displays its software version.
Basic settings of the room unit during setup
36
AFTER INSTALLING THE BATTERIES
"RU" appears on the room unit display
Push Enter (C) to automatically make an RF connection (pairing) between the
room unit and the RF transmitter.
When pairing is complete, "PAIR OK" appears on the display. Push Enter (C) to
open the setup menu (see the next page).
If a connection cannot be made, "PAIR FAIL" will appear on the display.
In this case, disconnect the transformer briefly from the motor unit and push
Enter (C) twice to restart pairing.
C - ENTER button
· Single push on the default screen:
displays a quick menu that shows the measured
indoor and supply water temperatures, calcu-
lated supply water set point, and valve position.
· Single push in a menu:
confirms a selection.
· Push and hold (for more than 3 seconds) on the
default screen:
navigates to the user menu.
D - Setup button
· Single push:
navigates to the setup menu.
www.vexve.com