Vexve AM20-W Benutzeranleitung Seite 37

Setup menu
Rotate the knob (A) to navigate the functions and push the Enter button (C) to modify an option. Select
the desired value by rotating the knob (A).
Values that can be changed will blink on the display, and the changes are confirmed by pushing the Enter
button (C).
1. MODE
LO = FLOOR HEATING
· With the DRY option you can activate the drying of a concrete floor
· With the INIT option you can set the starting temperature.
· With the STOP option you can set the stopping temperature.
· With the STEP option you can specify the daily temperature change
HI = RADIATOR HEATING
CT = CONSTANT TEMPERATURE CONTROL
With the SPD option you can choose the control speed from the range of 1-9
(1=slow, 9=fast). The factory setting is 4.
www.vexve.com
(according to standard EN 1264-4).
For example: INIT = 15°C, STOP = 30°C and STEP = 1°C » Heating is started
at 15 degrees, and the temperature is increased one degree each day until it
reaches 30°C. After this, the temperature is decreased one degree per day
until it is reaches 15°C
EN
37